Football Vibrator
What you need:
- Standard-sized foam football
- Long serrated knife
- Bullet vibrator with batteries
- Marker
At one end of the football, draw a circle around the point that’s about the
diameter of the bullet vibe. Use the knife to cut straight down into the
foam around the circumference of the circle, penetrating at least four
inches into the football. When you have cut completely around the circle,
pull out the foam plug that you’ve created. If necessary, use the knife to
trim out the foam near the bottom of the hole.
On the side of the football, a few inched from the end that you just cut
into, make another circle that is the size of the controller/battery pack
for the vibrator. Cut around the outside of the circle, straight in towards
the middle of the football so you’re making a tube that’s perpendicular to
the one in the end. Make sure the knife goes in far enough so it meets the
other hole. Extract the foam plug. If your vibrator’s controller is square,
you may want to cut a square or rectangular section out of the foam so you
can set it in flush with the surface.
Make sure you have put the batteries into the vibrator’s
battery pack. Now insert the bullet completely into the hole in the side of
the football. Push it up into the vertical hole so it will come out the end
of the football. You may have to insert fingers in both holes to push and
guide it through. When it’s aligned with the end of the ball, push any
remaining wires into the side hole and insert the controller, leaving the
knob or dial exposed. Now you’re ready for kickoff.
[Anal Sex Advice] |
Next Toy >> |
