Candy Corn Dildo

Skip the mini chocolate bars and make something that’s really “fun size.” Use the instructions and recipe below to create these tasty and colorful sex toys made from real candy corn candy. While these toys are firm enough for penetration, we suggest you use them only as a decoration or edible treat.

Instructions for Mold:

Choose the sex toys that you want to use as the models for your candy, or create a form out of clay or some other material. We fashioned our butt plug form out of clay. If you’re using a real sex toy to cast the mold, don’t use a valuable one; it may get damaged in the molding process.


Select milk carton containers of an appropriate size for your toys, and cut off the tops. Make sure you have a couple of inches to spare when the toy is sitting on the bottom of the carton.


Grease the sex toys with shortening or vegetable oil for easier release from the wax. Position in the bottom of the cartons, making sure they’re centered.


Melt paraffin wax over low heat on the stove. The amount of wax you need will vary depending on the size of your toys and the mold. You can estimate beforehand by filling the mold container with water and measuring. One pound of paraffin makes about 2 cups when melted. We used about 4 pounds of wax for two molds.


With the toy or mold form on the bottom of the container, carefully pour in the liquid paraffin. Make sure the level covers the top of the toy by at least an inch or more. The wax will sink in the center as it cools, so this area will become thinner. Let cool overnight until completely solid and peel off the paper carton.

Using a knife, cut the wax block in half vertically. Heating the blade over a flame can make cutting the wax easier. Cut around the toy from all sides, then pry the two halves of the mold open.



Grease the inside of the molds with shortening or vegetable oil. Reassemble the two halves and encircle with rubber bands to keep the mold together.


Using the following recipe, make candy corn candy. This recipe makes enough candy for one medium dildo and one small to medium butt plug.

Ingredients:

1/3 cup butter
2/3 cup white corn syrup
1 cup sugar
1 teaspoon vanilla
Yellow and red food coloring
3 cups powdered sugar
1/4 teaspoon salt
1/3 cup powdered milk

Directions for Candy:

In a bowl, sift together powdered sugar, salt and powdered milk. Combine sugar, corn syrup, and butter in a pan. Bring to a boil stirring constantly to prevent burning. Turn heat to low and boil 5 minutes, stirring occasionally. Remove from heat and stir in vanilla. Add powdered sugar mixture all at once to pan. Transfer to Kitchenaid mixer and beat on high speed, or beat by hand until candy has the consistency of soft taffy. The candy should still be warm and pliable, but you must work quickly before it cools.


Remove enough to form the white portion of the finished candy and set aside in a bowl. Add yellow food coloring to the remainder to achieve desired shade. Remove a portion of yellow base for the orange portion, and add red food coloring to achieve the desired shade of orange.


Starting with white, drop the candy into greased molds using a spoon or spatula. Allow each layer to settle to avoid air pockets. Repeat with yellow and orange layers. Let candy set overnight before unmolding. For maximum firmness, chill in refrigerator for several hours.

When completely hardened, carefully unmold and wipe any residual vegetable oil off the surface. If using for penetration, dust with cornstarch to reduce stickiness and cover with a condom (putting anything sugary into the vagina can result in yeast infections). Body heat may cause the candy to soften.

Copyright 2009 Homemade-Sex-Toys.com, all rights reserved.